I have turned the hull over since this last photo and I am presently preparing the foredeck, forward and aft seat planks to be put down with glue and screw. Simply stated, I'm sanding the Sand Dollar's parts.

I will hold off commenting on this project until its completion. I will then write about some of the points that remain clear to me in its construction at that time. Of course, being a first time builder, I will not have much in the way of meaningful experience to share with most of you. This of course will serve mostly me by merging the meaningful learning experiences from this project into one tiny spot on this universe.

My intention is to use this boat to learn a little bit about sailing in and around the protected waters of Long Island, N.Y., and anywhere else that will have me. Most importantly, I'm enjoying the building process so far.

This is my first significant woodworking project; therefore, I wouldn't expect any time-saving tips just yet. In future posts I intend to point out areas of difficulty, modifications, changes in procedure, etc...

I purchased the video and plans from the designer (link below). The information seems to be carefully written with the beginner in mind.


Work accomplished so far:

- Setting up a suitable work area. (on-going process)

- Ordered MAS epoxy resin / hardener along with 3 sheets of 6mm okoume (marine plywood)

- Ordered some tools (mostly clamps)

- I'm Halfway thru the shaping of the stem from 1 1/2" oak

Small caps, Goucho